 |
 |
|
<<O>> Difference Topic
CEL
(r1.2 - 20 Dec 2005 - Home.qwertyville)
|
|
|
| Changed: |
<
< |
Check Engine Light
| >
> |
Check Engine Light
|
| Changed: |
<
< |
On OBD0 cars, there is a window on the ECU through which a blinking LED can be seen to read codes.
| >
> |
- On OBD0 cars, there is a window on the ECU through which a blinking LED can be seen to read codes.
|
| Changed: |
<
< |
On OBD1 cars, there is a connector located under the dash by the passenger footwell that must be shorted. This will cause the dash CEL to blink, indicating which codes are being thrown.
| >
> |
- On OBD1 cars, there is a connector located under the dash by the passenger footwell that must be shorted. This will cause the dash CEL to blink, indicating which codes are being thrown.
|
| Changed: |
<
< |
If the CEL is lit solid and does not blink (after jumping the connector on OBD1 ) and the car runs poorly, in all likelyhood you have a bad ECU, a bad program/bad ROM, or a Check Sum error.
| >
> |
- On OBD2 cars, there is a connector located under the dash by the passenger footwell that must be shorted. This will cause the dash CEL to blink, indicating which codes are being thrown. You can also use an OBD2 scan tool which connects to the plug by the driver's side footwell. It is a gray connector that should be easily identifiable.
|
| Added: |
>
> |
Solid Check Engine Light
If the CEL is lit solid and does not blink (after jumping the connector on OBD1 ) and the car runs poorly the following could be the problem:
- A faulty ECU
- Poor soldering connections
- Check Sum error
- Faulty program stored in the ROM
- Faulty ROM chip
- Faulty 74HC373 chip
|
| Changed: |
<
< |
See Honda Error Codes
| >
> |
See Troubleshooting Solid CEL
|
| Added: |
>
> |
See Honda Error Codes |
|
<<O>> Difference Topic
CEL
(r1.1 - 04 Aug 2005 - Home.phiz)
|
|
|
| Added: |
>
> |
%META:TOPICINFO{author="phiz" date="1123128525" format="1.0" version="1.1"}%
Check Engine Light
This indicator (usually on the dash) comes on to indicate that the ECU thinks something is wrong. The ECU will usually indicate an error code by flashing the CEL in some manner.
On OBD0 cars, there is a window on the ECU through which a blinking LED can be seen to read codes.
On OBD1 cars, there is a connector located under the dash by the passenger footwell that must be shorted. This will cause the dash CEL to blink, indicating which codes are being thrown.
If the CEL is lit solid and does not blink (after jumping the connector on OBD1 ) and the car runs poorly, in all likelyhood you have a bad ECU, a bad program/bad ROM, or a Check Sum error.
See Honda Error Codes |
|
Copyright © 2002-present by the contributing authors. All material on this collaboration platform is the property of the
contributing authors, and is covered by the Non-Commercial Share-Alike License unless explicitly stated otherwise. |
|