<<O>> Difference Topic
CEL
(r1.3 - 22 Dec 2005 - Home.qwertyville)
|
|
Changed: |
< < |
If the CEL is lit solid and does not blink (after jumping the connector on OBD1 ) and the car runs poorly the following could be the problem:
| > > |
If the CEL is lit solid and does not blink (after jumping the service check connector on OBD1 ) and the car runs poorly the following could be the problem:
- A faulty ECU (means any other component failure other than listed here)
|
Added: |
> > |
"Phantom" Check Engine Light
Sometimes you may get a CEL that doesn't show up when you turn the car off. In order to check these, you must do the following:
- DON'T turn the ignition off
- Jump the service check connector just like normal
Now the CEL will turn off briefly and then start flashing the codes like normal. |
|
Copyright © 2002-present by the contributing authors. All material on this collaboration platform is the property of the contributing authors, and is covered by the Non-Commercial Share-Alike License unless explicitly stated otherwise. |
|