Location | Bytes | Description | Notes |
0630 | 3 | Injector test bypass #1 | Disable J label_063D(checked)03 3D 06 |
0B85 | 2 | Low Speed Ignition Map Config, Column Size | more info... |
0B87 | 2 | Low Speed Ignition Map Config, Row Size | more info... |
0B95 | 3 | Low Speed Ignition Map at this jump | more info... |
0BA1 | 2 | High Speed Ignition Map Config, Row Size | more info... |
0BA9 | 2 | High Speed Ignition Map at this jump | more info... |
120E | 1 | VTEC Coolant Temp Check | (enable=44/disable=FF) |
1520 | 3 | Injector test bypass #2 | Disable J label_153A(ckecked)03 3A 15 |
2315 | 3 | O2 Heater Jump Routine | Change to "03 50 23" to disable O2 heater |
2D43 | 2 | Rolling Target Idle | RPM = 1875000/(word at 0x2D43) |
2D58 | 2 | Cold Target Idle | RPM = 1875000/(word at 0x2D58) |
2D81 | 2 | Warm Target Idle | RPM = 1875000/(word at 0x2D81) |
3C02 | 3 | VTP Sensor Disable | Change to "03 1A 3C" to disable VTP sensor check (needs testing!) |
43A2 | 2 | IAB on | IAB open RPM RPM = 1875000/(word at 0x43A2) |
439D | 2 | IAB off | IAB close RPM RPM = 1875000/(word at 0x439D) |
5466 | 1 | Vtec Enable | (enable=FF/disable=00)(Needs Testing?) |
5467 | 1 | Knock Sensor | (enable=FF/disable=00) |
5468 | 1 | O2 Heater | (enable=FF/disable=00)(Needs Testing?) |
5469 | 1 | PA Sensor | (enable=FF/disable=00) |
546D | 1 | maybe injector test? |
547D | 1 | VTEC VSS Check | (enable=00/disable=FF) More info: Disable Vtec VSSCheck P72 |
547E | 1 | Debug Mode | (0xFF enables, 0x00 disables) More info: P72 Debug Mode |
5489 | 1 | Iab control | (0xFF enables, 0x00 disables) |
58DA | 1 | Rev Resume #1 | RPM = 1875000/(byte at this address) |
58E0 | 1 | Rev Cut #1 |
58E6 | 1 | Rev Resume #2 |
58EC | 1 | Rev Cut #2 | i think the following 4 points are wrong |
595A | 2 | Rev Limit #1 | more info... |
5960 | 2 | Rev Limit #2 |
5966 | 2 | Rev Limit #3 |
596C | 2 | Rev Limit #4 |
59A0 | | Vtec | more info... i think this is part of the low load xOver |
7C9A | | Low Fuel (10x20) | more info... |
7D6C | | High Fuel (10x15) |
7E0C | | Low Timing (10x20) |
7ED4 | | High Timing (10X15) |
7C54 | | MAP sensor scalers |
7C68 | | Rev scalers | low/high unknown |